A standardized operational process for bag making machines is outlined as follows:

1. Pre-Startup Preparations

① Check the area around the equipment for dust or debris, and clear any found.

② Load the film roll according to the specifications in the production order.

③ Adjust the bag dimensions based on the production order and technical documentation. Install the heat sealing knife and perform a preliminary adjustment.

④ Set the positions of the slitting knife and heat sealing knife.

⑤ Turn on the power and set the heat sealing knife temperature as required by the technical documentation.

⑥ Input the relevant bag-making parameters and the required quantity per bundle.

⑦ Adjust the sensitivity of the photoelectric sensor using pattern edges with high color contrast until it meets the requirements.

2. Startup Procedure

① Start the main motor at a low speed. Immediately adjust the edge guide control to center the film.

② Adjust the left and right nip rollers to align the film edges. Adjust the front and rear nip rollers to align the patterns correctly.

③ Adjust the heat sealing knife to ensure seals are within the specified bag areas.

④ Position the slitting blades as required and align the punching device with the cut point.

⑤ Set an initial machine speed. Collect a sample bag from the first stable production cycle for preliminary inspection.

⑥ Continuously monitor the bag-making process during operation and make immediate adjustments if any abnormalities are observed.

3. Shutdown Procedure

Turn off the main power switch, followed by disconnecting all individual power switches.